Setup Rode Wireless Go II For Broadcaster

Turn on your Rode Receiver and add one of the USB C cables. Plug in the USB (opposing end) to the matching port on your hub. (i.e iPhone: USBA + Ethernet Adapter)

If you're using a lavalier, connect your RODE Lavalier GO Professional-Grade Wearable Microphone to your Rode Mic. Then, turn on your Rode Mic.

We have learned that using this mic requires a lot of battery power, so you will want to be sure to charge your phone while streaming. 

Make sure your Rode devices are on. Here's what your setup may look like! 

Once connected, visit your Union Broadcaster app. In the lower right hand corner you can confirm what audio source is being detected. In this example, it shows GHW USB AUDIO (compared to iPhone Mic). If your Rode Wireless II is connected, to your phone but you're seeing iPhone Mic, we may need to manually change the audio input. Continue reading to learn how to change this. If your Rode is connected, please visit Create a Livestream Test Event!

Adjusting Your Audio Settings

Open the Union Broadcaster App and visit your Settings and scroll to Broadcast Settings. Then tap Audio.  

Then click on Input

Change from Auto to Headset Microphone. Click the back button (upper left corner)

Click the back button 

Then click Close

If your Rode Wireless Go II is still connected, you should see if listed in the lower right corner. 

Up Next, Create an Livestream Test Event in Union

Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.